W222 S350d 4MATIC: U0401 implausible engine data after a remap

A Mercedes S350d 4MATIC (W222, OM656 engine, Bosch MD1CP001 ECU) came back after a performance remap with the ESP warning on. The engine itself ran fine, with no engine fault codes. The faults were stored in the ESP control unit.

The fault codes

Code Status Description
U040181 Active and stored Implausible data received from combustion engine. Incorrect data received.
U0401EF Active and stored Implausible data received from combustion engine.
U0402FC Stored Implausible data received from transmission.
U0416FA Active and stored Implausible data received from traction system.

Why it happens

The engine ECU does not only make torque. It also reports torque on the CAN bus: the torque it is producing now and the maximum it can deliver. ESP, the gearbox and the 4MATIC transfer case all use these values. The ESP checks them against what is plausible for this vehicle variant.

In the remap, the maximum torque curves were raised by about 25%. On a rear-wheel-drive car that often goes unnoticed. On a 4MATIC the reported values went beyond what the ESP accepts, so it flagged the engine data as implausible and switched on the warning.

Lowering the torque limiter by a few percent was not enough. The value was still far above stock.

The approach

  1. Keep the reported torque at stock. Return the maximum torque curves that feed the CAN signal to their original values, and keep the gain from fuelling and boost. ESP then sees stock numbers, while the car still pulls harder.
  2. If the fault returns, also restore the torque limits for the transmission and drivetrain interface.
  3. Clear the codes in the ESP module after flashing, not only in the engine ECU. The stored U0401 stays until it is erased.
  4. Raise in small steps if more torque is wanted. The exact threshold the ESP accepts is variant-specific, so it has to be found by testing.

The trade-off: with stock torque limits the gain is smaller than with the full remap, roughly the fuelling and boost share. On a 4MATIC that is the price of a car without warning lights.

Takeaway

On all-wheel-drive Mercedes models, look at the U-codes in the ESP module before touching the engine file again. An “implausible data” code after a remap almost always points to the torque values the engine reports, not to a mechanical fault.