EDC16CP34: rebuilding a stock bench file from an OBD original
A common situation: a car arrives with a tuned Bosch EDC16CP34. You have the stock calibration as an OBD read, but the ECU has to be written on the bench, and the bench needs a full flash file. Here is how to build a stock bench file without guessing.
What each read contains
| Read | Size | Content |
|---|---|---|
| OBD | 2 MB | Only the calibration area 0x180000–0x1FFFFF (512 KB). Everything else is padding (FF). |
| Bench | 2 MB | The whole flash: boot, program and calibration. |
The procedure
- Check that both files are the same software. The software number (for example
1037383300) appears in both. If it differs, stop. A calibration from other software must never be placed on a program it was not made for. - Take the program from the bench read. Keep
0x000000–0x17FFFFexactly as read. - Take the calibration from the OBD original. Copy all of
0x180000–0x1FFFFFfrom the OBD file, including the block signatures at the end of the data blocks. - Verify byte by byte. The calibration area of the result must equal the OBD original, and the program area must equal the bench read.
- Let the tool check the checksum before writing, as usual.
What a tuned file looks like
In our case the bench read showed the usual signs of an earlier remap: torque, fuel and boost maps raised by about 10–15%, a few limiters opened, and the signature blocks at 0x1BFF7C and 0x1FDF7C zeroed. Copying the OBD calibration brings all of it back to stock, original signatures included.
Limit: this restores the calibration only. If an earlier tuner also patched the program area (for example to bypass checks), that patch stays. Confirming the program is stock needs a clean original of the full flash.