Delphi DCM6..1 · Diesel
Ford 2.0 TDCi 162 hp
Kuga
The Ford 2.0 TDCi 162 hp (119 kW) runs a Delphi DCM6..1 engine control unit. Our archive holds 5 calibration projects for it, model years 2016.
Spec sheet
- Make
- Ford
- Fuel
- Diesel
- Factory power
- 162 hp / 119 kW
- ECU
- Delphi DCM6..1
- Model years
- 2016
- EVC WinOLS projects
- 5 .ols
- File format
- EVC WinOLS (.ols) · BIN
Tuning & software solutions
Available for the DCM6..1 on this engine – combine them in one file.
Emission-related solutions are for off-road, motorsport and export use only, where permitted by local law.
Power & torque gains
Stage 1 power, torque and dyno chart for the Ford 2.0 TDCi 162 hp. Select: Cars/Vans → Ford → Kuga → 2.0 TDCi – 162hp.
ASF Academy
Learn to tune the DCM6..1 yourself
Delphi DCM6..1 is read with OBD or bench, with JTAG/BDM for recovery. In ASF Academy you practise reading and writing on real ECUs, then build the file in WinOLS and Stage X.
- Basic reading and writing · from 280 €
- Intermediate WinOLS and Stage X · from 350 €
- Advanced complete vehicle tuning · from 1,200 €
Same engine, other makes
- Ford only in our archive
How a file is made
- Read the ECU (OBD or bench, depending on your tool)
- Upload the original read to the ASF file portal
- Your software version is matched against the archive
- Verified file back in 5–60 minutes – EVC WinOLS project (.ols) or BIN
Need a file for this DCM6..1?
Upload your original read on the ASF file portal. The file is built for your exact software version – verified, not a generic map – and is usually ready in 5–60 minutes.
Stage 1
Stage 2
Stage 1