Delphi DCM6.X · Diesel
Ford 2.0 TDCi 150 hp
Kuga
The Ford 2.0 TDCi 150 hp (110 kW) runs a Delphi DCM6.X engine control unit. Our archive holds 3 calibration projects for it across 2 hardware numbers and 1 software versions, model years 2014–2016.
Spec sheet
- Make
- Ford
- Fuel
- Diesel
- Factory power
- 150 hp / 110 kW
- ECU
- Delphi DCM6.X
- Model years
- 2014–2016
- Hardware numbers
- 2
- Software versions
- 1
- EVC WinOLS projects
- 3 .ols
- File format
- EVC WinOLS (.ols) · BIN
Tuning & software solutions
Available for the DCM6.X on this engine – combine them in one file.
Power & torque gains
Stage 1 power, torque and dyno chart for the Ford 2.0 TDCi 150 hp. Select: Cars/Vans → Ford → Kuga → 2.0 TDCi – 150hp.
Hardware numbers
ECU part numbers in our archive (2 in total). Check the label on your ECU.
Software versions
3 EVC WinOLS (.ols) projects across 1 software versions. Calibrations differ per version – a file is always built for your exact one.
ASF Academy
Learn to tune the DCM6.X yourself
Delphi DCM6.X is read with OBD or bench, with JTAG/BDM for recovery. In ASF Academy you practise reading and writing on real ECUs, then build the file in WinOLS and Stage X.
- Basic reading and writing · from 280 €
- Intermediate WinOLS and Stage X · from 350 €
- Advanced complete vehicle tuning · from 1,200 €
Same engine, other makes
- Ford only in our archive
How a file is made
- Read the ECU (OBD or bench, depending on your tool)
- Upload the original read to the ASF file portal
- Your software version is matched against the archive
- Verified file back in 5–60 minutes – EVC WinOLS project (.ols) or BIN
Need a file for this DCM6.X?
Upload your original read on the ASF file portal. The file is built for your exact software version – verified, not a generic map – and is usually ready in 5–60 minutes.
Other engines with the DCM6.X
| Engine / model | ECU | Models | Years | WinOLS .ols |
|---|---|---|---|---|
| Volkswagen 2.0 Diesel 204 hp | DCM6.X | Caravelle | 2 |
Stage 1
Stage 2
Stage 1