Bosch ME7.8.3 · Petrol
Porsche 3.6 Petrol 473 hp
911
The Porsche 3.6 Petrol 473 hp (348 kW) runs a Bosch ME7.8.3 engine control unit. Our archive holds 2 calibration projects for it across 1 hardware numbers and 1 software versions, model years 2008.
Spec sheet
- Make
- Porsche
- Fuel
- Petrol
- Factory power
- 473 hp / 348 kW
- ECU
- Bosch ME7.8.3
- Model years
- 2008
- Hardware numbers
- 1
- Software versions
- 1
- EVC WinOLS projects
- 2 .ols
- File format
- EVC WinOLS (.ols) · BIN
Tuning & software solutions
Available for the ME7.8.3 on this engine – combine them in one file.
Emission-related solutions are for off-road, motorsport and export use only, where permitted by local law.
Power & torque gains
Stage 1 power, torque and dyno chart for the Porsche 3.6 Petrol 473 hp. Select: Cars/Vans → Porsche → 911 → 3.6 Petrol – 473hp.
Hardware numbers
ECU part numbers in our archive (1 in total). Check the label on your ECU.
Software versions
2 EVC WinOLS (.ols) projects across 1 software versions. Calibrations differ per version – a file is always built for your exact one.
ASF Academy
Learn to tune the ME7.8.3 yourself
Bosch ME7.8.3 is read with OBD for read and write, boot mode for a full read. In ASF Academy you practise reading and writing on real ECUs, then build the file in WinOLS and Stage X.
- Basic reading and writing · from 280 €
- Intermediate WinOLS and Stage X · from 350 €
- Advanced complete vehicle tuning · from 1,200 €
Same engine, other makes
- Porsche only in our archive
How a file is made
- Read the ECU (OBD or bench, depending on your tool)
- Upload the original read to the ASF file portal
- Your software version is matched against the archive
- Verified file back in 5–60 minutes – EVC WinOLS project (.ols) or BIN
Need a file for this ME7.8.3?
Upload your original read on the ASF file portal. The file is built for your exact software version – verified, not a generic map – and is usually ready in 5–60 minutes.
Stage 1
Stage 2
Stage 1