Delphi DCM3MBCRD2 · Diesel
Mercedes-Benz 2.1 CDI 136 hp
E-Class
The Mercedes-Benz 2.1 CDI 136 hp (100 kW) runs a Delphi DCM3MBCRD2 engine control unit. Our archive holds 2 calibration projects for it across 1 hardware numbers and 1 software versions.
Spec sheet
- Make
- Mercedes-Benz
- Engine code
- OM651
- Fuel
- Diesel
- Factory power
- 136 hp / 100 kW
- ECU
- Delphi DCM3MBCRD2
- Hardware numbers
- 1
- Software versions
- 1
- EVC WinOLS projects
- 2 .ols
- File format
- EVC WinOLS (.ols) · BIN
Tuning & software solutions
Available for the DCM3MBCRD2 on this engine – combine them in one file.
Power & torque gains
Stage 1 power, torque and dyno chart for the Mercedes-Benz 2.1 CDI 136 hp. Select: Cars/Vans → Mercedes-Benz → E-Class → 2.1 CDI – 136hp.
Hardware numbers
ECU part numbers in our archive (1 in total). Check the label on your ECU.
Engine codes
Engine and calibration variants found in our archive.
Software versions
2 EVC WinOLS (.ols) projects across 1 software versions. Calibrations differ per version – a file is always built for your exact one.
ASF Academy
Learn to tune the DCM3MBCRD2 yourself
Delphi DCM3MBCRD2 is read with OBD or bench, with JTAG/BDM for recovery. In ASF Academy you practise reading and writing on real ECUs, then build the file in WinOLS and Stage X.
- Basic reading and writing · from 280 €
- Intermediate WinOLS and Stage X · from 350 €
- Advanced complete vehicle tuning · from 1,200 €
Same engine, other makes
- Mercedes-Benz only in our archive
How a file is made
- Read the ECU (OBD or bench, depending on your tool)
- Upload the original read to the ASF file portal
- Your software version is matched against the archive
- Verified file back in 5–60 minutes – EVC WinOLS project (.ols) or BIN
Need a file for this DCM3MBCRD2?
Upload your original read on the ASF file portal. The file is built for your exact software version – verified, not a generic map – and is usually ready in 5–60 minutes.
Stage 1
Stage 2
Stage 1